TM 10-3510-208-12
TS 3510-208-12/4-49
Figure 4-49. Tumbler solenoid and bracket, removal and installation.
open flame or excessive heat. Flash point
of solvent is 100 to 138F. (38 to 59C.).
Clean metal parts with cleaning solvent, Fed.
Clean all parts in a weIl-ventilated area.
Spec. P-D-680, and dry thoroughly.
Avoid inhalation of solvent fumes and
c. Inspection and Repair.
prolonged exposure of skin to cleaning
solvent. Wash exposed skin thoroughly.
(1) Inspect all parts for damage.
(2) Replace all damaged parts.
Dry cleaning solvent (Fed. Spec. P-D-680)
used to clean parts is potentially dangerous
d. Installation. Refer to figure 4-49 and install
to personnel and property. Do not use near
Section XV. TUMBLER BURNER, EXHAUST MOTOR AND RELATED PARTS,
D R I V E MOTOR CONDUIT BOX, DRIVE MOTOR AND
R E L A T E D PARTS
4-41. Tumbler Burner
(3) Remove the conduit (3) from the burner
assembly.
a. Removal.
securing the burner assembly (6) to the dryer-
the conduit box cover (2) to the conduit box.
tumbler.
(2) Tag and disconnect all wiring to the
burner assembly.
4-62