2-45. DRYER FUEL PUMP ASSEMBLY (CONT)
Install fuel pump (8) on air intake housing (9)
and secure with two bolts (7).
The fuel pump shaft must be aligned
with the fuel pump impeller coupling
before assembling the air intake and
Install tee (5), with pressure gage (6) and drain
valve (1) attached, on fuel pump (8).
Uncap and install input fuel line (2), output fuel
line (3), and fuel return line (4).
Return the fuel line caps to the storage bins.
Close fuel drain valve (1).
Adjust fuel pump pressure.
Power must be applied to the dryer, and the dryer and fuel pump must be
operating before fuel pump pressure can be adjusted.
Remove acorn nut (31) from pressure adjusting screw (36).
Turn pressure adjusting screw (36) until pressure gage (6) indicates 120 5 psi (827 34 kPa).
Install acorn nut (31) on pressure adjusting screw (36).
Install tarp assembly (TM 10-3510-209-10).