TM 10-3510-209-24
3-19. WATER HEATER
REMOVAL
1.
Unlatch and open cover on circuit box (2).
2.
Cut and remove wire ties (1) on inside of circuit box (2) as required.
3.
Loosen thumbscrew (3) and remove cover (4).
4.
Loosen two screws (5) and remove PC board (6).
5.
Remove two screws (7) and remove limit switch (8) from circuit box (2).
NOTE
A record of wire removal is needed so that installation hookup is exactly
duplicated. See FIGURE 2-5.
6.
Remove screws (9) and tag and disconnect six wires (10).
7.
Remove screw (11) and tag and disconnect wire (12).
8.
Remove conduit nut (13), conduit (14), and wires (15) from control box (2).
9.
Install PC board (6) and tighten two screws (5).
10.
Install cover (4) and tighten thumbscrew (3).
3-84