WASHER ASSEMBLY (CONT)
Components of the washer assembly are
heavy and may be awk ward to handle.
Use correct lifting procedures, lifting
devices, and/or assistance from other
personnel to avoid injury.
Install shaft seal.
Press in new seals (69) into seal carrier
(68) and lubricate with petrolatum, item
8, appendix C.
Apply silicone sealant around shaft
openings on back side of drum.
Loosely install washers (72) and nuts (71)
on studs on back of drum. Do not tighten.
Gently slide basket shaft through seals
(69) and gear reducer (70).
Tighten nuts holding seal carrier
Align keyway in basket shaft with key-
way in gear reducer and install key (41).
Reinstall drum front and drawbands. (See
Assembly, paragraph 1).
Install collars on each side of gear reducer.
(See Assembly, paragraph 3).
Fill washer and check for water leaks.