3-15. EXTRACTOR ASSEMBLY (CONT)
Remove and replace brakeshoe.
High voltage is present on this equipment.
Do not perform maintenance with power
on. Death or serious injury may result.
a. Place extractor circuit breaker on
electrical panel in OFF position.
b. Open extractor lid (23).
Components of the extractor are heavy and
may be awkward to bundle. Use correct
lifting procedures, lifting devices, and/or
assistance from other personnel to avoid
Remove extractor basket (24).
Remove two brass bolts (28), flat
washers (29), and gaskets (30).
Remove capscrew (25), lockwasher
(26), and drain clamp (27). Remove
curb (31) from base (32).
Measure thinnest part of brake shoe
(33) lining. Replace brakeshoe if
lining thickness measures less than
1/8 inch (3.2 mm).