3-42. HINGE SHAFT ASSEMBLY - continued.
Open and close extractor lid (28) several times and note if lid opens and closes properly.
If excessive force must be used to open/close lid or lid is too loose (lid closes on its own), tighten or loosen
adjustment screw (19) on brake (18) as required for proper operation.
If required, install gasket (5) using adhesive.
Install cover (4) with lockwashers (2), seal washers (3) and twelve bolts (1).
Install lid closed switch (Para 3-49) and lid locked switch (Para 3-50).
Figure 3-34. Hinge Shaft Assembly