TM 10-3510-223-13&P
0031 00
0031 00-4
Remove Sleeves.
This procedure requires two MOS 51R, 52C, 52D, or 52G.qualified persons. To remove the connector
sleeves (1) dust covers (2) and gasket (3) from the power entry panel (4), loosen and remove the pan
head screws (5) flat washers (6) and self locking nuts (7) holding the sleeves (1) to the panel (4). Retain
the screws, washers and nuts. Remove and discard the sleeve (1) and gasket (3).
Remove Ground Post.
To remove the ground post (1), remove the rear cover of the power entry box (2). Remove the hex nuts
(3), flat washers (4), lock washers (5), and ground wires (6) from the ground terminal. Push the ground
post terminal (1) out of the power entry box (2).
6
7
4
3
1
2
5
1
2
6
3
3
3
4
4
5