TM 10-3510-223-13&P
0041 00
0041 00-2
Install the repaired washer/dryer into the CSSL as described under INSTALL, below.
Washer Drive Belt Replacement. To replace the washer drive belt,
proceed as follows:
Remove the washer/dryer to be repaired from the CSSL as described
under REPLACE and REMOVE, below.
Lay washer on front. Loosen the water pump as described above
under Water Pump Belt Replacement, and remove the water pump
belt from the drive pulley (1).
Remove the broken drive belt (2) from the drive (1) and drum pulley
(3). Move motor on its track towards the drum pulley to obtain sufficient
slack, and place a new belt onto the drive and drum pulley.
Reinstall pump belt. Tighten water pump and adjust pump belt (4) as
described above under Water Pump Belt Replacement.
Install the repaired washer/dryer into the CSSL as described under
REPLACE, below.
REPLACE
Prior to replacing a washer/dryer, open the curbside double service doors on the container to gain access
to the rear of the washer/dryer. Disconnect the power cord (1) of the washer/dryer(s) to be replaced from
the ceiling raceway (2). Separate the 15-pin electrical cord connector (3) on the rear of the washer. Close
both ball valves (4) on freshwater line.
WARNING
The washer/dryer and stand are heavy. To avoid injuries, two persons
are required to lift and handle the washer/dryer and stand.
Remove
Remove fresh water hoses (5), wastewater hose (6), and exhaust ducts (7) from washer/dryer(s) to be
replaced. Retain hoses and ducts. Remove sheet metal elbow duct (8) from dryer(s) to be replaced and
retain. Remove hex screws and flat washers (9) securing top of dryer units to support frame (10). Remove
hex nuts (11) and flat washers (12) securing top frame (10) to container wall and lift frame off the washer/
dryer units. Remove front (13) of washer by removing two retainer screws (14). Using a cross-tipped
screwdriver, remove two bolts (15) from rear of the washer/dryer frame. Slide washer out of the stand
(16).
3
4
1
2