TM 10-3510-223-13&P 0005 00
Two personnel are required to lift light set case to avoid injury.
To prevent damage leave luminaires in case until ready to install.
Be sure male plug end is toward the CSSL.
Wrap light hanger strap (1) around each end of luminaire (2) on inside of rubber end caps (3).
Pull strap (1) up through the D ring (4) and press down to engage hook and pile fastener (5).
Mate plug properly to next luminaire (2), ensuring reflecting surface faces up and lamp faces down.
Repeat steps above for additional luminaires.
Repeat for second luminaire on other side of TEMPER section. Plug the luminaries (2) together on the
end opposite the CSSL.