TM 10-3510-226-23
0042 00
REPLACE-CONTINUED
Replace the Door Unlocked Switch
WARNING
Ensure that all electrical power is shut off and disconnected before proceeding. The
circuit breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
NOTE
This switch is normally open (NO).
2. Cut the wire ties (Figure 7, Item 1) retaining switch wiring to the washer frame. There may be one or
two wire ties.
3. Open washer door.
4. Remove screws retaining door strike assembly (Figure 7, Item 2) and remove door strike assembly.
5. Tag and disconnect wiring from unlock switch (Figure 7, Item 3).
6. Remove screws retaining switch (Figure 7, Item 3) to door strike assembly (Figure 7, Item 2) and
remove switch.
7. Install replacement switch (Figure 7, Item 3) onto door strike assembly (Figure 7, Item 2) and retain
with screws.
8. Connect wiring to replacement switch (Figure 7, Item 3) as tagged.
9. Install door strike assembly (Figure 7, Item 2) and retain with screws.
10. Retain wiring with wire tie (Figure 7, Item 1).
12. Close washer door, and operate IAW procedures given in TM 10-3510-226-10.
0042 00-11