SECTION I. INTRODUCTION
Code
Explanation
1. Scope
and can be assembled to form the required
This manual lists repair parts required for the
assembly
at
indicated
maintenance
performance of direct support and general support
categories.
maintenance of the repair shops.
X
Parts and assemblies which are not procured or
stocked and the mortality of which normally
2. General
is below that of the end item or component.
This Repair Parts and Special Tools List is divided into
The failure of such part or assembly should
the following sections:
result in retirement of the end item from the
supply system.
authorized for the performance of maintenance at the
X1
Repair parts which are not procured or stocked.
direct support and general support level in figure and
The requirement for such items will be filled
item number sequence.
by use of the next higher assembly or
b. Special Tools, Test and Support Equipment-
component.
Section III. A list of special tools, test and support
X2
Repair parts which are not stocked.
The
equipment authorized for the performance of
indicated maintenance category requiring
maintenance at the direct support and general support
such repair parts will attempt to obtain
level (not applicable).
same through cannibalization. Where such
c. -Index-Federal Stock Number and Reference
repair parts are not obtainable through
Number-Section IV. A
list of
Federal stock numbers in
cannibalization, requirements will be
ascending numerical sequence followed by a list of
requisitioned,
with
accompanying
reference numbers in ascending alphanumeric
through
normal
supply
sequence, cross-referenced to the illustration figure
channels.
number and item number.
G
Major assemblies that are procured with PEMA
Note. Items not illustrated are cross-referenced to
funds for initial issue only as exchange
page number.
assemblies at DSU and GSU level. These
assemblies will not be stocked above DSU
3. Explanation of Columns
and GSU level or returned to depot supply
The following provides an explanation of columns in the
level.
tabular lists on sections II and III.
(2) Maintenance code indicates the lowest
a. Source, Maintenance, and Recoverability Codes
category of maintenance authorized to install the listed
(SMR).
item. The maintenance level codes are:
(1) Source code indicates the selection status
Code
Explanation
and source for the listed item: Source codes used are:
O
Organizational maintenance
Code
Explanation
F
Direct support maintenance
P
Repair parts which are stocked in or supplied
H
General support maintenance
from the GSA/DSA, or Army supply system
(3) Recoverability code indicates whether
and authorized for use at indicated
unserviceable items should be returned for recovery or
maintenance categories.
salvage.
Items not coded are expendable.
P2
Repair parts which are procured and stocked for
Recoverability Codes are:
Code
Explanation
military essentiality of the end item dictates
R
Applied to repair parts and assemblies which
that a minimum quantity be available in the
are economically repairable at DSU and
supply system.
GU activities and are normally furnished by
M
Repair parts which are not procured or stocked,
supply on an exchange basis.
but are to be manufactured in indicated
S
Repair parts and assemblies w ich are
h
maintenance levels.
economically repairable at DSU and GSU
A
Assemblies which are not procured or stocked
activities and which are normally furnished
as such, but are made up of two or more
by supply on an exchange basis. When
units.
Such component units carry
items are determined
individual stock numbers and descriptions,
are procured and stocked separately
iii