TM 10-4510-207-14
Table 2-1. Operator Preventive Maintenance Checks and Services for SHOWER-1 Continued
Location
Interval
Not Fully Mission
Item
Procedure
Item to be
Capable If:
No.
Checked or
Serviced
Shower Facility
After
Using a bristle brush, scrub brush base to remove
8
Portable
soap buildup.
Shower Base
Open showerheads and allow water to run until
water leaving drain hose is clear.
Shut off supply and diaphragm (drain) pumps.
Using a bristle brush, scrub floor panel to remove
After
9
Floor Panel
soap buildup.
Rinse with clear water.
Using a bristle brush, scrub floor mat to remove
After
10
Floor Mat
any dirt.
Rinse with water.
Container damage or
After
Check for damage or missing hardware and any
11
Storage
hardware missing.
damage to container.
Container
SECTION III OPERATION UNDER USUAL CONDITIONS
2.6 ASSEMBLY AND PREPARATION FOR USE.
The portable shower module is shipped disassembled with parts in six storage containers. The pump assembly is
the only item shipped loose. Table 2-2 lists the content of each storage container.
2.6.1. Site Selection. The portable shower module should be assembled on a site that is as level as possible and
well drained. The portable shower module must be near an electrical power source, clean water source, and
wastewater disposal site. If these items are not available, they must be provided before assembly. Carefully
review the assembly instructions to determine the optimum location for connection to these systems.
2-7