Ensure all circuit breakers on circuit breaker panel are set to the OFF position to prevent
shorting of equipment when power is initially established.
1. Lay out one 60A, 50-foot cable pigtail (1) in front of the electrical panel to the power source.
2. Connect pigtail (1) to the 60A power supply receptacle (2).
The following step must be performed by MOS 52C or 52D qualified personnel. Failure to
observe safety precautions may result in injury or death from electrocution.
3. Connect pigtail (1) to power source (e.g., generator, municipal power supply, etc.).