TM 5-6350-255-13 .
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS AND SPECIAL TEST EQUIPMENT
5-1. Special Test Equipment
5-2. Maintenance Repair Parts
Repair parts are listed and illustrated in Appendix C of
this manual.
Section II. TROUBLESHOOTING
cept when malfunction and cause are obvious), or is not
5-3. Scope
corrected by listed corrective actions, you should notify
a. This section contains troubleshooting or
higher level maintenance.
malfunction information and tests for locating and
c. Table 5-1 lists the common malfunctions that
correcting most of the troubles which may develop in the
you may find during the operation or maintenance of the
MINISID III. Each malfunction or trouble symptom for an
MINISID III or its components. You should perform the
individual component, unit, or system is followed by a list
tests Inspections and corrective actions in the order
of tests or inspections necessary for you to determine
listed.
probable causes and suggested corrective actions for
you to remedy the malfunction.
NOTE
b. This manual cannot list all possible malfunctions
Before you use this table, be sure you have
that may occur or all tests or inspections, and corrective
performed all normal operational checks. If you
actions. If a malfunction is not listed (ex
have a malfunction which is not listed in this
table, notify the next
Table 5-1. TROUBLESHOOTING
MALIFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 1. The checkout procedures of the MINISID III which isolates a malfunction to a replaceable assembly are as follow
5-1