LO 10-3510-222-12
GENERAL NOTES
This LO is for operator/crew (C) and unit (0) maintenance. Lube intervals (on-condition or hard time) are based on
normal operation. Lube during constant use, and less during inactive periods. The task-hour specified is the time you
need to do all the services prescribed for a particular interval. Use correct grade of lubricant for seasonal temperature
expected.
On the picture, a dashed line (--) means there are lubrication points on both sides of the equipment.
Laundry Unit cannot operate at/or below 32 (0 ). If temperature will be at/or below 32 (0 ), operate Laundry Unit
F
C
F
C
in suitable shelter.
This Laundry Unit is not enrolled in the Army Oil Analysis Program. HARDTIME INTERVALS APPLY.
Refer to TM 10-3510-222-10 for Corrosion Prevention and Control.
The lubrication intervals and symbols are listed below:
M = Monthly
Q = Quarterly
S = Semiannually
A = Annually
Before you start your lubrications:
NEVER
ALWAYS
a. Use wrong type/grade grease.
a.
Clean grease fittings before lubrication.
b. Use too much lubricant.
b.
Use the lubrication order as your guide.
c.
After lubrication, wipe excess grease from fittings to
prevent build up of dirt, grit, and contaminants.
d.
Normally drain gear case when hot.
Fill and check oil level.
Card 2 of 12
