TM 1-1680-354-10
CHAPTER 2
OPERATING INSTRUCTIONS
SECTION I. DESCRIPTION AND USE OF OPERATOR'S CONTROLS
AND INDICATORS
2.1
OPERATOR'S CONTROLS AND INDICATORS.
a.
A chemical contamination detector is used only during wartime conditions and in war zone areas. Refer to
Chapter 2, Section IV, when the detector does not give you a normal reading.
b.
Safety Relief Valve. Before opening the rigid container, press the safety relief valve to equalize the pressure.
SECTION II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
(PMCS)
2.2
GENERAL.
The operator is responsible to check the anti-pilferage seal for possible tampering of the AMSS.
2.2.1 PMCS Procedures.
a.
Operator Preventive Maintenance Checks and Services (PMCS). Table 2-1 lists the inspections required by the
operator.
b.
The Item No. column gives the order in which the PMCS will be performed (in numerical order). This column is
used as a source of item numbers for the TM Number column on DA Form 2404 in recording results of PMCS.
c.
The Interval column describes when to do a certain check or service.
d.
The Item to be Checked column explains how to do the required checks and services.
e.
The Not Fully Mission Capable if: column states the criteria by which the equipment cannot be used until
corrective maintenance has been performed.
Change 1
2-1
