TM 10-3510-209-24
Section III. INTERMEDIATE DIRECT SUPPORT MAINTENANCE PROCEDURES
Para
Title
Page
3-7
General Maintenance Procedures .....................................................................
3-11
3-8
Tarp Cover Assembly.......................................................................................
3-13
3-9
Lower Sound Deadening Track.........................................................................
3-14
3-10
Washer Assembly ............................................................................................
3-15
3-11
Washer Controller Assembly.............................................................................
3-31
3-12
Controller Stand ...............................................................................................
3-40
3-13
Washer Drive Motor Maintenance .....................................................................
3-42
3-14
Power Distribution Panel...................................................................................
3-46
3-15
DELETED........................................................................................................
3-55
3-16
Extractor Assembly ..........................................................................................
3-59
3-17
Extractor Drive Unit ..........................................................................................
3-69
3-18
Extractor Control Box .......................................................................................
3-76
3-19
Water Heater ...................................................................................................
3-83
3-20
Water Heater Electric Control Assembly ............................................................
3-88
3-21
Water Heater Blower Motor Assembly ...............................................................
3-101
3-22
Water Heater UV Scanner and Flame Safeguard Assembly................................
3-104
3-23
Water Heater Operating Limit and High-Limit Controls........................................
3-108
3-24
Dryer Assembly ...............................................................................................
3-112
3-25
Dryer Electric Control Assembly........................................................................
3-114
3-26
Dryer UV Scanner and Flame Safeguard Assembly............................................
3-118
3-27
Dryer Exhaust Motor and Fan Assembly............................................................
3-123
3-28
Dryer Tumbler Drive Motor and Gearbox ...........................................................
3-126
3-29
Water Pump.....................................................................................................
3-134
3-7. GENERAL MAINTENANCE PROCEDURES.
a.
Electric Motor and Generator Repair. Repair electric motors and generators in accordance with TM 5-764.
b.
Wiring.
(1)
General. Wires on laundry units, whether run individually or in a harness, are marked or numbered. Be
sure to tag any unnumbered wire upon disconnection to ensure proper installation.
(2)
Inspection. Inspect insulation for cracks or frayed material. Pay particular attention to wires passing
through holes in the frame or over rough metal edges. If wire is cut or broken and the break in the wire is exposed, the
wire must be repaired as in step (4) below. If the break in the wire is in a harness, conduit, or inaccessible area, replace
the wire as in step (5) below.
3-10 Change 1
