TM 10-3510-209-24
2-15. BEAM ASSEMBLY (CENTER AND RIGHT)
This task covers:
a. Inspection
c. Repair
e. Installation
b. Removal
d. Replacement
INITIAL SETUP
Tools
General Safety Instructions
General mechanic's tool set,
SC 5180-90
WARNING
Heli-arc welding equipment
(as needed)
Trailer bed can be cluttered and is slippery
Painting equipment (as needed)
if wet. Use care when climbing onto or
walking around the mounted equipment.
Personnel Required
Equipment Condition
MOS 63J (2)
TM 10-3510-209-10. Tarp, ladder, struts, and
Materials/Parts
left beam assembly removed.
Paragraph 2-16, Hose bin assemblies removed.
Beam assembly components
Paragraph 2-17, Upper and lower sound deadening
(as needed)
panels removed.
Remove air hoses from center beam by
removing tie down straps as necessary.
INSPECTION
Inspect beam assembly for cracks, breaks, bends,
corrosion, missing hardware, and other damage that
weakens the metal.
REMOVAL
1.
Remove two lanyard pins (1), one pin on each end
from right beam (2) and beam holders (3).
2.
Lift right beam (2) from beam holders (3) and
remove beam from trailer.
3.
Repeat steps 1 and 2 for center beam.
2-64 Change 2
