TM 10-3510-220-10
2-4.
GENERAL MAINTENANCE PROCEDURES. As you perform your PMCS, keep in
mind the
a.
b.
c.
d.
e.
following:
Cleanness. Dirt, grease, oil, and debris only get in the way and may cover up
a serious problem.
Bolts, Nuts, and Screws.
Check them all for obvious looseness and missing,
bent, or broken condition. You cannot try them all with a tool, of course, but
look for chipped paint, bare metal, or rust around bolt heads. If you find one
you think is loose, report it to your supervisor.
Welds.
Look for loose or chipped paint, rust, or gaps where parts are
welded together. If you find a bad weld, report it to your supervisor.
Electrical Wires and Connections. Look for cracked or broken insulation, bare
wires, and loose or broken connectors. Tighten loose connections and make
sure the wires are in good condition.
If your find a bad wire or
connect or, report it to your supervisor.
Water Lines and Fittings.
Look for wear, damage, and leaks. Make sure
clamp and fittings are tight.
Wet spots show leaks, but a stain around a
fitting or connector can mean a leak.
If a leak comes from a loose fitting or
connector, or if something is broken or worn out, report it to your supervisor.
2-5.
OPERATOR/CREW PREVENTIVE MAINTENANCE CHECKS AND SERVICES
TABLE.
a.
b.
c.
d.
See table 2-1 for operator preventive maintenance checks and services
(PMCS).
Refer to TM 5-6115-585-12, Generator Set, Diesel Engine Driven, 10 kW, 60
Hz, for operator preventive maintenance checks and services (PMCS) for the
generator set.
Refer to TM 9-2330-376-14&P for operator preventive maintenance checks
and services (PMCS) for the laundry unit trailer.
The Daily Walk-Around PMCS Routing Diagram will be of help to complete B,
D, A, or W PMCS. It shows laundry unit PMCS routing track which matches
the sequence of PMCS to be performed.
2-15
