TM 10-3530-207-14
2-13. OPERATING PROCEDURES FOR BUTTON SEWING MACHINE - continued.
s. To Stop the Forward and Backward
Motion of the Feed Plate.
To stop the forward and backward
motion of the feed plate, when sewing
shank buttons, position nut (1) as far as
it will go to the right (as when sewing
two-hole flat buttons).
t. Through and Through Stitching Leather
Shank Buttons.
NOTE
Stop the motion of the feed carrier plate, as
instructed in paragraph 2-13s.
(1) The figure shows a leather shank button
held in place in button holder (1) and
button finger (2) and is the work support
for through and through stitching of
leather shank buttons.
(2) Button holder (1) is attached and
adjusted as instructed in paragraph 2-
13r.
(3) Button finger (2) is adjusted as instructed
in paragraph 2-13r.
2-93
