TM 10-3530-207-14
5-24. CLOTHING SEWING MACHINE STITCH LENGTH REGULATOR MAINTENANCE - continued.
Installation - continued.
(3) Install spring (6) in small hole of bracket (7).
(4) Slide lever (1) and shaft (2) into the machine head. Slide bracket (7) and crank (8) onto shaft (2)
Secure with setscrews (9) on the respective flat spots on the shaft (2).
(5) Continue to slide shaft (2) into the machine head making sure that crank (8) fits into the feed
regulator fork and the end of shaft (2) fits into the hole in the machine head.
(6) Install screw (10).
(7) Install bracket (11) securing with two screws (12).
(8) Attach spring (6) onto bracket (11).
(9) Screw feed regulator screw (13) into the machine. Make sure it bottoms out against the notched
area of feed regulator fork.
(10) Install pin (14) and spring (15).
NOTE
Make sure the pin on the back of the dial (16) is pressed against the left side of pin
(14) before tightening screw (17).
(11) Install dial (16) onto feed regulating screw (13) and secure with screw (17).
5-58
