TM 10-3530-207-14
2-8.
ASSEMBLY AND PREPARATION FOR USE - continued.
d.
Opening Up The Trailer continued.
(4) Unhook trailer end gate chains (1) and lower trailer end gate
(2).
(5) Open rear door (3) and make sure rear door stays (4) hold
the door open.
NOTE
As the cabinet assembly is unloaded, check the equipment
against the Components of End Item List (COEIL) contained
in Appendix C of this manual to insure that the clothing repair
shop is complete.
e.
Folding Table Assemblies. There are two folding table assemblies: one is used for the installation
and operation of the heat sealer during operation of the Clothing Repair Shop and one is used for the
installation and operation of the grommet press at one end, the tack-button machine at the other end
and the ironing board in the middle.
(1) Remove two locking pins (5) and remove the two table
assemblies (6) from the slides in the rear of the cabinet.
NOTE
The table assemblies may be snug and not slide freely. If
so, gently pry out from front.
(2) Unfold the legs and lock them in place by sliding the locks
downward into position to set up the tables.
2-41
