TM 10-8400-201-23
8-7. REPAIR AND MAINTENANCE-Continued
(f)
Replace missing or defective drawcord eyelets with material specified in section III.
(g)
Replace missing or defective hardware with items identical in design, dimensions, and color to
pieces being replaced.
(5)
Sizing. After repair and/or laundering, size all Items, using tables listed below. Check sizes with original
markings and change if necessary. Hoods that do not meet size requirements of table 8-2A below will not
be reissued for wear. All size markings will be stamped out with indelible ink. Size all caps and hats in
accordance with table 8-2. When measurements do not conform with the table, mark with the next lower
size.
Table 8-2. Resizing Instructions
(FINISHED MEASUREMENTS IN INCHES)
A - COLD WEATHER HOOD
LOCATION
INCHES
TOLERANCE
PLUS
MINUS
*OVERALL LENGTH
34
3/4
1/2
**NECK
24
3/4
1/2
***BRIM WIDTH
4 1/2
1/4
1/4
STORM CURTAIN WIDTH
6 5/8
1/4
1/4
***SKIRTWIDTH
4 1/4
1/4
1/4
* Overall length. Measure from bottom of storm curtain to front edge of brim in alignment with center seam at top
of hood.
** Neck. Measure along length of seam which joins skirt to hood on inside.
*** Brimwidth.
Measure in alignment with center panel at
Skirt width.
top of hood.
}
8-11
