TM 10-8400-201-23
10-8. LABELING
Each garment will have a combination identification-size label and an instruction label, or a combination identification-
size instruction label conforming to Type I of DDD-L-20 Repair or remark labels to provide required information. Replace
labels which cannot be repaired by remarking with new ones located adjacent to or sewn over the old label.
a. Instruction Label. Label information shall be printed in letters not less than 10-point and shall read as follows'
COAT, COLD WEATHER: FIELD
1.
Wear as outer garment or as under-layer in cold dry climate
2.
Wear button-in liner for added insulation.
3.
Adjust closures and drawcords to ventilate; avoid overheating of body.
4.
When hood is used, lower extension shall be worn over neck opening, preventing water entering opening.
5.
Brush snow or frost from garments before entering heated shelters.
6.
For fast drying, remove liner from coat.
7.
Do not expose to high temperature of a stove.
8.
Lubricate slide fasteners with wax.
9.
For cleaning and restoring of water repellency, return to laundry for machine washing In accordance with
established procedures for quarpel treated garments
10. Machine Washing: Use permanent Press Cycle. Wash in warm water using mild detergent.
11. Hand Washing: Wash in warm water using mild detergent. DO NOT WRING OR TWIST. Rinse in clean warm
water.
12.
DO NOT USE CHLORINE BLEACH OR STARCH.
13.
Drying. Dry at low heat (do not exceed 130F). After drying, tumble at room temperature for 10 minutes.
Remove immediately from dryer To drip dry, remove from water and place on a rust-proof hanger.
DO NOT REMOVE THIS LABEL
TROUSERS, MEN'S, COTTON AND NYLON WIND RESISTANT SATEEN, M-65, OG107
Wear as outer garment in cold-wet climate or as inner layer of cold-dry uniform.
Button In liner for extra warmth. Remove it when damp or wet and allow to dry.
Attach suspender hooks to waist loops.
Adjust waist by buckle straps.
Ventilate by loosening drawcords.
10-12
