TM 10-8400-203-23
4-4 HELMET - Continued
Figure 4-4. Adjusting model DH-132 helmet for wear (Sheet 2 of 2)
Section Il. REPAIR PROCEDURES
4-5. GENERAL
The instructions in this section are published for the information and guidance of organizational and direct support main-
tenance personnel. Repair and cleaning will be performed by personnel skilled in the particular trade applicable to their
duties.
4-6. INSPECTION, CLEANING, AND REPAIR
a.
Helmet Shell.
(1)
(2)
(3)
Inspect the helmet shell for cleanness, cracks, loose rivets, and damaged straps.
Inspect the two screws and nuts located at the front of the helmet shell for looseness. These are the
screws that hold the snap fasteners in place. Apply thread sealant, NSN 8030-00-081-2330, to the screws
and re-thread the screws through the nuts on the inside of the helmet shell.
Clean the helmet with soap and warm water, and rinse it with water. Wipe the helmet dry with a clean cloth.
4-6
