TM 10-8400-203-23
15-5. REPAIR AND MAINTENANCE OF BODY ARMOR Continued
Table 15-1, Body Armor Vest (PASGT) Measurements
MEASUREMENTS
SIZE (INCHES)
X-SMALL
SMALL
MEDIUM
LARGE
X-LARGE
1/2 Chest
18 1/2
19
1/2
21 1/2
23 1/2
25 1/2
Back Length
20 1/2
23 1/4
23 3/4
24 1/4
24 3/4
NOTE
One-half chest measurement taken from folded edge to folded edge of the
vest at the base of armhole level. Back length measurement taken along
center of back from top edge of neck (center back) to bottom edge of shell.
If the outer shell is to be removed and replaced, it is important that the label containing the size, stock number
and cleaning instructions be retained for stitching to the new shell. If label is unusable replace label entirely. The
aramid ballistic insert should be checked to insure that the size is marked and will be retained.
b. Cleaning Instructions
(1)
(2)
(3)
(4)
(5)
(6)
Remove loose dirt from touch and close fastener and outer cover surface using a cloth or soft brush.
NEVER USE A STIFF BRISTLE BRUSH.
Wet the vest in the shower or immerse in water. Use warm, not hot water.
Apply toilet soap or detergent to the soiled areas and scrub with a soft brush. Badly soiled areas may
be scrubbed with GI soap. Scrub only long enough to remove soil.
Grease and oil stains may be pre-spotted with a detergent mixture and scrubbed with a soft brush. If
stubborn stain persists, repeat the above procedure.
Rinse the vest with warm water until suds are completely gone.
Hang the vest to dry, away from heat or open flame by placing a stick or pole through the armholes.
Do not use dry cleaning
c. Outer Shell Repair Procedure.
solvents, gasoline or similar products to clean the vest.
15-6
