TM 9-1005-237-23&P
e. Column 5, Tools and Equipment. Column 5 specifies, by code, those common
tool sets (not individual tools) and special tools, TMDE, and support equipment
required to perform the designated function.
f. Column 6, Remarks. This column shall, when applicable, contain a letter
code, in alphabetic order, which shall be keyed to the remarks contained in
section IV.
B-4. EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS,
SECTION III.
a. Column 1, Reference Code. The tool and test equipment reference code corre-
lates with a code used in the MAC, section II, Column 5.
b. Column 2, Maintenance Category. The lowest category of maintenance authorized
to use the tool or test equipment.
c. Column 3, Nomenclature. Name or identification of the tool or test equipment.
d. Column 4, National Stock Number. The National stock number of the tool or
test equipment.
e. Column 5, Tool Number. The manufacturer’s part number.
B-5. EXPLANATION OF COLUMNS IN REMARKS, SECTION IV.
a. Column 1, Reference Code. The code recorded in column 6, section II.
b. Column 2, Remarks. This column lists information pertinent to the maintenance
function being performed as indicated in the MAC, section II.
Section II. MAINTENANCE ALLOCATION CHART
FOR
M6 BAYONET-KNIFE WITH SCABBARD,
M7 BAYONET-KNIFE WITH SCABBARD AND
M9 MULTIPURPOSE BAYONET SYSTEM
(1)
GROUP
NUMBER
00
01
(2)
MAINTENANCE CATEGORY
COMPONENT/ASSEMBLY
M6, M7, M9, and M1O
M6
(3)
MAINTE-
NANCE
FUNCTION
INSPECT
SERVICE
REPLACE
REPAIR
INSPECT
SERVICE
REPLACE
REPAIR
(4)
UNIT
c
0.1
0.1
0.1
0.1
0
0.1
0.1
0.1
0.1
0.1
0.1
D.S.
F
—.
0.1
0.2
——
:.s.
H
—-
—-
m-
D
—.
—.
(5)
TOOLS
AND
EQPT
1
1
1
1,2
(6)
REMARKS
.
—
B-4
