Test the Washer 3-Way Valve
Ensure that all electrical power is shut off and disconnected before proceeding. The
circuit breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
The washer is extremely heavy. Use caution when moving and blocking the washer, and
do not allow unnecessary personnel in the immediate area while it is being moved.
Serious injury or death may result if safety precautions are not observed.
The washer is a large, heavy piece of machinery being moved out of a confined space.
Before removal and installation, remove or protect any equipment that might be damaged
by the washer on its way in or out.
The valve has three solenoids that must be tested separately.
However, only two
solenoids are connected and used in the washer.
2. Tag and disconnect wiring from valve (Figure 2, Item 1).
4. Replace a valve (Figure 2, Item 1) with an open solenoid.
5. Reconnect wiring as tagged.