1
Set, generator
6
Stands, shower
2
Drum, fuel
7
Pump assembly, water
3
Hose assemblies, fuel feed
8
Hose assembly, suction
and return
9
Hose assembly, water pump heater
4
Heater, water
10
Strainer, water pump heater
5
Hose assemblies, water
11
heater-to-shower stand
12
NOTE
This manual covers the Orr & Sembower Model 8SH-1,
Army Model SPE 35; the York-Shipley Model 8-SH-60,
Throughout this manual, the use of
Army Model SPE 35A; the York-Shipley Model 8-SH-62,
the terms right, left, front and rear
Army Model SPE 41; York-Shipley Model 8-SH-63, Army
for the water heater indicates from
Model SPE 44, York-Shipley Model YS49279; and York-
the viewpoint of the operator as he
Shipley Model 8-SH-70YS, Army Model SPE 45. The
operates and faces the burner fuel
differences in the models covered in this manual are
shutoff valve and the burner fuel
minor, and where the differences exist, they are indicated
control valve. The use of these
in the applicable paragraphs by the particular Army Model
terms for the water pump also
Number. The difference in Army Model SPE 45 from
indicates the directions from the
previous models is the incorporation of a newly designed
viewpoint of the operator as he
pressure and temperature control assembly. Refer to
faces the control panel box.
b. Tabulated Data. Certain 3 kw
generator sets are
1-6. Identification and Tabulated Data
matched with specific bath unit models and they are as
a. Identification. The bath unit has two plates; one
follows:
instructional plate and one data plate and they are located
NOTE
as follows:
The
Hollingsworth
and
the
SZEMCO Model generator sets are
(1) End item instruction plate. The bath unit
being replaced by the Military
instruction plate (fig. 1-2) is located on the side of the
Design DOD Model MEP-016A.
water heater tank.
(2) End item data plate. The bath unit data
plate (fig. 1-3), which identifies the complete end item, is
mounted on the lower right end of the water heater.