TM 10-3510-208-12
Clean the step assembly with cleaning solvent,
b. Cleaning
Fed. Spec. P-D-680, and dry thoroughly.
c. Inspection and Repair.
Clean all parts in a well-ventilated area.
{1) Inspect the step assembly for cracks,
Avoid inhalation of solvent fumes and
breaks and other damage.
prolonged exposure of skin to cleaning
(2) Weld minor cracks and breaks.
solvent. Wash exposed skin thoroughly.
d. Installation. Refer to figure 4-115 and install
Dry cleaning solvent (Fed. Spec. P-D-680)
used to clean part is potentially dangerous
the step assembly.
to personnel and property. Do not use near
open flame or excessive heat. Flash point
of solvent is 100 to 138F. (38 to 59C. ).
4-163
