TM 10-3510-209-10
Section III. OPERATION UNDER USUAL CONDITIONS
Para
Title
Page
2-6
Scope........................................................................................................................... 2-30
2-7
Site Selection, Setup, and Assembly............................................................................ 2-30
2-8
Preparation for Use ..................................................................................................... 2-47
2-9
Operating Procedures .................................................................................................. 2-62
2-10
Preparation for Movement ........................................................................................... 2-69
2-11
Operating Instructions on Decals and Instruction Plates............................................... 2-74
2-6.
SCOPE.
This section contains procedures for operation of the laundry unit.
2-7.
SITE SELECTION, SETUP, AND ASSEMBLY . Components are mounted or stored on the trailer for
shipment and storage. During use, some components are removed from the trailer. The setup instructions that
follow include steps for unpacking and positioning components. Components should be unpacked only when
the facility is planned for use or when maintenance is needed. FIGURE 2-9 shows the laundry unit as it would
be for shipping or storage, without the cover.
a.
Select a site for the laundry unit that has adequate water and drainage for operational needs.
Select a relatively level area, approximately 75 square feet (6.97 sq m).
(1)
Position the laundry unit so that the water heater is next to the water source.
(2)
Set the handbrake lever, lower the trailer supports, and unhitch towing vehicle. If necessary,
dig holes or block wheels to ensure the trailer is level. Refer to TM 9-2830-276-14&P.
(3)
Remove tarp assembly and inspect it for cuts, frays, weather rot, and damage. If tarp assembly
is damaged, notify your supervisor.
(4)
Remove bottom bolts from transportation braces (1) on the left side of trailer assembly. Rotate
transportation braces downward into the vertical position.
2-30 Change 1
