TM 10-3510-209-10
2-9. OPERATING PROCEDURES. (CONT)
(2)
Select the proper formula from FM 10-280.
(3)
Turn the cylinder to a blank position on the formula chart. In manual operation, first control
finger (position 11) must make contact with the cylinder; all remaining contact fingers must
not contact the cylinder.
(4)
Check the air tank pressure gage for a pressure of at least 60 psi (414 kPa).
NOTE
Washer will not fill with water if the drain switch is in the open position.
(5)
Select DRAIN, WATER LEVEL, and WATER TEMPERATURE switch positions and MOTOR
switch operation as desired.
(6)
Set MASTER switch to MANUAL position and set timer to desired setting. The washer will fill
with water to the selected level of the selected temperature.
(7)
Set TIMER ENABLED switch in the down position.
(8)
Add the washing supplies through the soap chute.
NOTE
Washing will continue indefinitely until the DRAIN switch is placed in the OPEN
position. The DRAIN switch starts and stops each operation during manual wash.
(9)
When SIGNAL LIGHT lights and buzzer sounds, set TIMER ENABLED switch to cancel
position and set DRAIN switch to open position. Wait approximately 1 minute.
(10)
When the machine has drained, the DRAIN switch may be moved to the SHUT position to
commence another operation.
(11)
Upon completion of MANUAL operation, set MASTER switch to OFF position.
(12)
Transfer laundry to the pre-extraction bin.
2-66
