TM 10-3510-209-24
3-10. WASHER ASSEMBLY (CONT)
DISASSEMBLY
1.
Remove drive motor.
NOTE
To remove belt cover and electrical
connections
refer
to
REMOVAL,
steps 3 and 4.
a.
Loosen two adjusting bolts (27) on the
side of adjusting tray (28) and release tension on
drivebelt (32).
b.
Remove four bolts (29), lockwashers (30),
and nuts (31).
c.
Remove drivebelt (32) from pulley (36)
and remove motor (33) from adjusting tray (28).
d.
Remove two bolts (39), lockwashers (35),
pulley (36), and key (37) from motor (33).
e.
Remove drivebelt (32) from pulley (4b).
2.
Remove gear reduction unit.
a.
Remove two bolts (38), lockwashers (39),
pulley (40), and key (41) from gear reduction unit (48).
b.
Remove
four
bolts
(42)
from
gear
reduction unit (48).
WARNING
Components of the washer assembly
are heavy and may be awkward to
handle.
Use
correct
lifting
procedures, lifting devices, and or
assistance from other personnel to
avoid injury.
c.
Support gear reduction unit (48). Remove
four nuts (43) from side braces (44).
3-19
