TM 10-3510-220-10
2-9. OPERATING PROCEDURES. (CONT)
f. Shutdown Procedures.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
NOTE
The laundry unit may begin to be shut down while the last load of wash
is being dried.
Make certain that all washer control panel switches are in the OFF position.
Turn off air compressor circuit breaker (3, figure 2-6) at the power distribution panel.
Turn water temperature control (7, figure 2-4) to O°F (-18°C). Allow the water heater to operate for 2
minutes so that the blower may purge vaporized fuel horn the burner. Turn ON/OFF switch(8) to the OFF
position and close fuel shutoff valve (10). Open drain valve (14) and drain water from heater. Close valve
(14).
Turn off start switch (1, figure 2-5) on the water pump. Open petcock valve (2) and drain water from pump.
Close valve (2).
When drying operations are complete, turn dryer temperature control (9, figure 2-2)to0°F(-18°C). Allow
the dryer to operate for 2 minutes so that the blower may purge vaporized fueI from the burner. Press
the STOP/RESET button (5) and close fuel shutoff valve (13).
Open the dryer door and allow the dryer to cool for 3 to 5 minutes.
If laundry is shutdown for preparation for movement, or if temperature will be below 32 degrees
Fahrenheit (0 Celsius), follow sub steps below:
(a)
(b)
(c)
(d)
On washer air tank, make sure gauge shows at least 80 psi.
Remove cap from washer recirculating drain.
On backside of washer control panel, locate air line to close recirculating drain valve. Cycle
solenoid of closed valve three times to drain water.
Install cap on recirculating drain.
WARNING
Water heater can produce scalding water. To avoid injury, be careful
when draining water.
2-68
Change 2
