TM 10-3510-220-24
2-24.3.
HOLDING TANK (WATER REUSE SYSTEM cont.)
DISASSEMBLE (cont.)
5.
6.
7.
8.
Remove bushing (12), nipple (13) and
coupling (14) from float switch closed
(11).
Remove elbow (15), nipple (16) and
elbow (17) from holding tank (7).
Remove elbow 90 degree compression
fitting (18) from conduit (19).
Remove conduit (19) from junction box
tree (5).
REPAIR
NOTE
Remove and replace only those items necessary to make repair.
Repair of holding tank assembly is limited to the replacement of component parts.
ASSEMBLE
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Install conduit (19) to junction box tee (5).
Install elbow 90 degree compression fitting (18) to conduit (19).
Install elbow (17), nipple (16) and elbow (15) to holding tank (7).
Install coupling (14), nipple (13) and bushing (12) to float switch closed (11).
Position float switch closed (11) in holding tank (7).
Position wire and install junction box tee (5).
Install bushing (10) to float switch open (9).
Position float switch open (9) in holding tank (7).
Position wire and install conduit (18).
Install shroud (8) to holding tank (7).
Change 1
2-78.11
