TM 10-3510-220-24
3-14. POWER DISTRIBUTION PANEL (CONT)
INSTALLATION (Cont)
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Feed wires (20) from connector (21) through connector box (19). Attach connector (21) to
connector box (19) using four screws (23) and four lockwashers (22).
Insert rubber grommet (18) into hole on side of panel box (5). Feed wire (20) through gasket
(17) and rubber grommet (18) into panel box (5). Apply vulcanized adhesive to both sides of
gasket (17) item 23, appendix C, and position connector box (19) and gasket (17) and secure
from inside panel box with four screws (24) and four flatwashers (25).
Reconnect wires (20) to panel box (5). Remove tags.
Feed wires (30) into panel box (5). Install conduit assembly (29) and chase nipple (28) on
panel box.
Reconnect wires (30) to panel box (5). Remove tags.
Feed wires (14) into panel box (5). Install cable assembly (13) and nut (15) on panel box.
Reconnect wires (14) to panel box (5). Remove tags.
Feed wires (38) into panel box (5). Install cable assembly (11) and nut (12) on panel box (5).
Reconnect wires (38) to panel box (5). Remove tags.
Install neutral wire (27) on connector block (26) and tighten large hex head set screw.
Remove tag.
Install neutral wire (31) on connector strip (33) and tighten set screws (32). Remove tags.
Install three ground wires (34) and three ground wires (37) on bus bar (36) and secure with six
set screws (35).
3-52
