TM 10-3510-220-24
3-14. POWER DISTRIBUTION PANEL (CONT)
REMOVAL (Cont)
NOTE
Tag wires before removal.
6.
Tag three ground wires (34) and three ground wires (37). Remove six set screws (35) from bus
bar (36) and six ground wires from panel box (5).
7.
Loosen set screws (32). Tag and remove neutral wires (31) from connector strips (33).
8.
Loosen large hex head set screw on connection block (26). Tag and remove neutral wire (27)
from connector blocks.
CAUTION
Carefully remove cable assemblies from panel box to prevent stripping
insulation from the wires.
9.
Remove nut (12) and cable assembly (11) from panel box (5). Tag and remove associated wires
(38) from panel box (5).
10. Remove nut (15) and cable assembly (13) from panel box (5). Tag and remove associated wires
(14) from panel box (5).
11. Remove chase nipple (28) and conduit assembly (29) from panel box (5). Tag and remove
associated wires (30) from panel box (5).
12. Remove four screws (24) and four flatwashers (25). Remove connector box assembly (16)
including gasket (17). Tag and remove associated wires (20) from panel box (5). Remove
rubber grommet (18) from panel box (5).
13. Remove four screws (23) and four flatwashers (22) to separate connector (21) from connector
box (19). Feed wires (20) through connector box (19).
3-49
