TM 10-3510-220-24
2-15. BEAM ASSEMBLY (CENTER AND RIGHT)
This task covers:
a. Inspection
b. Removal
c. Repair
d. Replace
e. Installation
INITIAL SETUP
Tools
Equipment Condition
General mechanic’s tool kit,
TM 10-3510-220-10, Tarp, ladder, struts and left
Heli-arc welding equipment
beam assembly removed.
(as needed)
Paragraph 2-16, Basket assemblies removed.
Painting equipment (as needed)
Paragraph 2-17, Upper and lower sound deadening
panels removed.
Personnel Required
Two
General Safety Instructions
WARNING
Trailer bed can be cluttered and is slippery if wet.
Use care when climbing onto or walking around the
mounted equipment.
INSPECTION
Inspect beam assembly for cracks, breaks,
bends, corrosion, missing hardware, and
other damage that weakens the metal.
REMOVAL
1.
Remove two lanyard pins (1), one pin
on each end from right beam (2) and
beam holders (3).
2.
Lift right beam (2) from beam
holders (3) and remove beam from
trailer.
3.
Remove air hoses from center beam
by removing tie down straps as
necessary.
4.
Repeat steps 1 and 2 for center beam.
2-51
