TM 10-3510-222-10
2-7. ASSEMBLY AND PREPARATION FOR USE - continued.
a.
Initial Preparation - continued.
(b)
Undo pile fastener tape on weather flap.
(c)
Remove half-hitch knot.
NOTE
Lacing is on all four corners of tarpaulin. Unlace one corner at a time.
(d)
Undo lacing.
(e)
After all four corners are open, fold sides up on top of tarpaulin and then fold the ends of tarpaulin.
(f)
Fold tarpaulin in half(lengthwise) then fold again. Keep folding until desired size is achieved for
storage.
(5)
Remove bottom bolts, washers, and nuts from tarpaulin support frames (1) on the street sid e of Laundry
Unit. Rotate tarpaulin support frames down. Store hardware in toolbox.
b.
Work Platform. See figure 2-10.
WARNING
Requires two people for lifting various components. Failure to observe proper lifting procedures
may result in serious injury to personnel.
(1)
Remove single acting pin (12) from upright (13).
(2)
Remove upright (13) and store under wet washer bin.
(3)
Remove short clamp (1 i1) and store in toolbox (4).
(4)
Slide washer platform (1) toward front of trailer and remove washer platform (1) from trailer.
(5)
Remove long clamp (10) from short platform (2) and dryer platform (3) and store long clamp in tool box
(4).
(6)
Remove short platform (2) from trailer.
(7)
Remove single acting pin (12) from upright (13).
(8)
Remove upright (13) and store under wet washer bin.
(9)
Slide dryer platform (3) toward front of trailer and remove washer platform from trailer.
2-37
