TM 10-3510-222-24
4-6. AC MOTOR - continued.
(2) ASSEMBLY
(a) Install boot (22) and protector (21) in electrical box (20), with two screws (19).
NOTE
Wire numbers are stamped on each electrical wire. This
information, in conjunction with data on FO-2 Washer Wiring
Diagram, may be used to connect wires if tags are lost or illegible.
(b)
Connect wiring to protector (21) as tagged.
(c)
Position gasket (18) and cover (17) on electrical box (20) and install four screws (16).
(d)
Install fitting (15) on stator band (9).
(e)
Install bearing (14) on rotor (12).
(f)
Install rotor (12) in stator band (9).
(g)
Install bearing (13) on rotor (12).
(h)
Install spring (11) on rotor (12).
(i)
Install fitting (10) on endplate (3).
(j)
Install endplate (3) on stator band (9).
(k)
Install four bolts (8), nuts (7) on endplate (3) and stator band (9).
CAUTION
Fan is made of plastic and may break. Be careful when handling.
(l)
Install fan (6) approximately 1/8 inch on rotor (12).
(m)
Install bolt (5) and nut (4) on fan (6).
(n)
Position cover (2) on endplate (3) and install three screws (1).
(o)
Install motor and plate (Paragraph 2-30).
4-7
