TM 10-3510-223-13&P 0005 00
0005 00-26
Component Installation
While the frame is partially-erect install light supports and luminaries as follows:
WARNING
Lethal voltage is present when cables are connected to power control
system. Ensure cables are disconnected from power source when working
with cables or fixtures. Electrical shock or death may result from failure to
heed this warning.
CAUTION !
Allow slack in electrical cables. Strain on cable can damage equipment.
Wrap extension cable (1) once around the header (2) to relieve strain.
Identify light support strap assembly (1) in light set case.
Wrap each running end of light support strap assembly (1) once around header (2) at header/arch joint
so the double D-ring (3) faces the tent roof.
Secure end of light support strap assembly (1) through double D-ring (3) assembly on standing end of
strap. Tighten webbing until taut.