TM 10-3510-226-23
0053 00
TEST-CONTINUED
Test the Washer Variable Frequency Drive Cooling Fan
WARNING
Ensure that all electrical power is shut off and disconnected before proceeding. The
circuit breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
WARNING
The washer is extremely heavy. Use caution when lifting and blocking the washer, and
do not allow unnecessary personnel in the immediate area while it is being moved.
Serious injury or death may result if safety precautions are not observed.
CAUTION
The washer is a large, heavy piece of machinery being moved out of a confined space.
Before removal and installation, remove or protect any equipment that might be damaged
by the washer on its way in or out.
NOTE
For Washer No. 2, steps 1 and 9 may be omitted. There is also no need to remove the
back, side, or top panels to perform this maintenance task.
1. Remove washer IAW procedures given in WP 0041 00.
2. Remove screws retaining inverter box cover (Figure 2, Item 1) and remove cover.
3. Tag and disconnect wiring from fan (Figure 2, Item 2).
4. Use an ohmmeter to check for 750 ohms resistance between motor leads (Figure 2, Item 3).
5. Use an ohmmeter to check for infinite resistance between each motor lead (Figure 2, Item 3) and
ground.
6. Replace a fan with an open motor or a motor which has shorted to ground.
7. Reconnect wiring as tagged.
8. Install inverter box cover (Figure 2, Item 1) and retain with screws.
9. Install washer IAW procedures given in WP 0041 00.
0053 00-2
