TM 10-3510-226-23
UNIT MAINTENANCE
CONTAINERIZED BATCH LAUNDRY
NSN 3510-01-527-2209
NSN 3510-01-527-2210
WASHER
REMOVE/ INSTALL
INITIAL SETUP
Tools
Personnel Required
Tool Kit, General Mechanics: Automotive (WP
Quartermaster and Chemical Equipment Repairer 63J
(2)
Materials/Parts
Equipment Condition
None Required
CBL set up
REMOVE
Remove the Washer
WARNING
Ensure that all electrical power for the washer is shut off and disconnected before
proceeding. The circuit breaker box should be locked by personnel following this
procedure. Serious injury or death can result from electrocution if proper safety
precautions are not observed.
WARNING
The washer is extremely heavy. Use caution when lifting and blocking the washer, and
do not allow unnecessary personnel in the immediate area while it is being moved.
Serious injury or death may result if safety precautions are not observed.
CAUTION
The washer is a large, heavy piece of machinery being moved out of a confined space.
Before removal and installation, remove or protect any equipment which might be
damaged by the washer on its way in or out.
1. Disconnect washer power cord (Figure 1, Item 1). Secure the cord to the washer to ensure it will not
snap or be damaged when the washer is moved.
2. Disconnect washer soap dispenser tubing (Figure 1, Item 2) and soap dispenser control cable
(Figure 1, Item 3).
3. Close off hot and cold water supply valves (Figure 1, Item 4) to washer (Figure 1, Item 5).
4. Disconnect hot and cold water supply hoses (Figure 1, Item 6) to washer (Figure 1, Item 5).
