TM 10-3510-226-23
0058 00
REPLACE-CONTINUED
Replace a Solenoid
WARNING
Ensure that all electrical power to the automatic soap dispenser is shut off and
disconnected before proceeding. The circuit breaker box should be locked by personnel
following this procedure. Serious injury or death can result from electrocution if proper
safety precautions are not observed.
WARNING
Use caution when handling laundry chemicals. Chemicals can cause injuries due to
chemical burns, poisoning, and hazardous vapors. Failure to observe safety and
handling precautions may cause injury or death to personnel
1. Disconnect power from the automatic soap dispenser.
2. Unlatch key lock and remove cover (Figure 5, Item 2).
3. Tag and disconnect the wiring from the solenoid (Figure 5, Item 3), and remove the solenoid.
4. Tag and disconnect the solenoid (Figure 5, Item 3) water connections.
5. Remove the screws retaining the solenoid (Figure 5, Item 3), and withdraw the solenoid from the
automatic soap dispenser housing.
6. Install the solenoid (Figure 5, Item 3) into the automatic soap dispenser housing.
7. Connect the solenoid (Figure 5, Item 3) water connections as tagged.
8. Connect the wiring to the replacement solenoid (Figure 5, Item 3) as tagged.
9. Secure the solenoid (Figure 5, Item 3) to the automatic soap dispenser housing with screws.
10. Install cover and latch. Connect power, and monitor for normal operation.
0058 00-7
