TM 10-3510-226-23
0063 00
REPLACE-CONTINUED
Replace the Lint Compartment Thermistor
WARNING
Ensure that all dryer electrical power is shut off and disconnected before proceeding.
The circuit breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
1. Disconnect power by switching the dryer circuit breaker to OFF.
2. Remove lint panel.
3. Remove screws retaining thermistor bracket (Figure 9, Item 2) and remove thermistor and bracket as
an assembly.
4. Remove screws retaining thermistor guard (Figure 9, Item 3), and remove guard.
5. Tag and disconnect wiring from thermistor (Figure 9, Item 4).
6. Remove thermistor (Figure 9, Item 4) by unscrewing the thermistor from the bracket.
7. Install replacement thermistor (Figure 9, Item 4).
8. Reconnect wiring to thermistor (Figure 9, Item 4) as tagged.
9. Install thermistor guard (Figure 9, Item 3) and retain with screws.
10. Install thermistor (Figure 9, Item 4) and bracket (Figure 9, Item 2) as an assembly and retain with
screws.
11. Install lint panel.
12. Switch the circuit breaker to ON and monitor for normal operation.
0063 00-15
