TM 10-3510-226-23
0067 00
REPLACE
Replace the Cylinder Drive Motor
WARNING
Ensure that all dryer electrical power is shut off and disconnected before proceeding.
The circuit breaker box or individual circuit breaker should be locked and tagged out by
personnel following this procedure. Remember that the CBL is a wet environment.
Serious injury or death to personnel can result from electrocution if proper safety
precautions are not observed.
WARNING
Ensure that the dryer power is shut off and disconnected before proceeding. Rotating
machinery and belts may snag fingers, hair, or clothing. Failure to observe safety
precautions may result in serious injury or death to personnel.
1. Disconnect power by switching the dryer circuit breaker to OFF.
2. Remove screws retaining belt guard and remove belt guard.
3. Remove screws retaining junction box cover (Figure 3, Item 1) and remove junction box cover.
4. Tag and disconnect wiring from motor (Figure 3, Item 2).
5. Remove conduit locknut, and remove conduit (Figure 3, Item 5) from junction box.
6. Adjust motor to relieve tension on belt (Figure 3, Item 6).
7. Remove screws, washers, and nuts retaining motor (Figure 3, Item 2) to motor mount and remove
motor.
8. Install replacement motor (Figure 3, Item 2), and secure in place with screws, washers, and nuts.
9. Install inner belt (Figure 3, Item 7) onto replacement motor (Figure 3, Item 2) and adjust to -inch
deflection.
10. Remove screws retaining junction box cover (Figure 3, Item 1) on replacement motor (Figure 3, Item
2), and remove cover.
11. Knock out conduit plug, if necessary.
12. Install conduit (Figure 3, Item 5) into junction box, and retain with locknut.
13. Connect wiring to replacement motor (Figure 3, Item 2) as tagged.
14. Install junction box cover (Figure 3, Item 1) onto replacement motor (Figure 3, Item 2), and retain
with screws.
15. Install belt guard and retain with screws.
0067 00-5
