TM 10-3510-226-23
0080 00
DIRECT SUPPORT MAINTENANCE
CONTAINERIZED BATCH LAUNDRY
NSN 3510-01-527-2209
NSN 3510-01-527-2210
RAMP
REPAIR
INITIAL SETUP
Tools
Personnel Required
Shop Equipment, Automotive Maintenance and
Quartermaster and Chemical Equipment Repairer 63J
Repair: Organizational Maintenance, Common
(1)
No.1 (WP 0086 00, Table 2, Item 5)
Equipment Condition
Materials/Parts
Rod, Welding (WP 0087 00, Item 45)
CBL set up.
REPAIR
Repair the Ramp
NOTE
The ramp is made of aluminum alloy, and must be welded with gas shielded arc welders
or with aluminum rods specifically made for conventional arc welders.
1. Remove ramp (Figure 1, Item 1) from service.
2. Weld damage to ramp (Figure 1, Item 1). Fabricate patches of 1/8-inch aluminum sheet as
necessary. Use of diamond plate for patches is preferable.
WARNING
Ensure repaired ramp is not warped in any way. Ensure ramp alignment is correct.
Failure to observe precautions may produce a tripping hazard, creating a potential for
serious injury or death to personnel.
3. Ensure repaired ramp (Figure 1, Item 1) fits correctly.
