TM 10-3530-207-14
3-8. TROUBLESHOOTING TABLE.
Refer to Table 3-1.
Table 3-1.
Operator Troubleshooting
WARNING
Be sure to read all Warnings in front of manual before troubleshooting.
NOTE
Before you use the troubleshooting tables, be sure you have performed all applicable operating checks and
verified that a malfunction exists. When a corrective action is performed, verify that the action has corrected
the malfunction. All malfunction deferred to the next higher level of maintenance must be reported according
to the instructions given in DA PAM 738-750.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CABINET ASSEMBLY
1.
HOLDDOWN CLAMP ASSEMBLY LOOSE.
Check capscrew, clamp arm, and machine screws.
If capscrew, clamp arm, machine screws or nuts are loose or obviously damaged, notify next higher
level of maintenance.
2.
REAR DOOR OR A SIDE DOOR CANNOT BE OPENED.
Step 1. Inspect door for dirty, cut, broken, or dented surfaces; broken welds; and a bad door gasket.
a.
Clean dirty surfaces using soap and water.
b.
Notify next higher level of maintenance for cut, broken, dented surfaces or welds, and
bad door gasket.
Step 2. Check that folding handle lock is not bent, broken, loosely mounted or missing. If folding hand
lock is defective or missing, notify next higher level of maintenance.
Step 3. Check that door hinge is not broken or bent. If door hinge is broken or bent, notify next higher
level of maintenance.
3-9
