TM 10-3530-207-14
Table 3-1. Operator troubleshooting - continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
GROMMET PRESS
45.
HANDLEVER STICKS ON DOWNSTROKE.
Check frame and handlever pivot for dirt or other obstruction.
Clean inside of frame and pivot.
46.
FASTENERS ARE LOOSE.
Step 1. Be sure you are using enough downward hand pressure on lever.
Apply hand pressure on lever more firmly.
Step 2. Check that snap fastener parts are inserted properly.
Insert snap fastener parts properly in chucks and dies (para. 2-14d).
47.
MACHINE CUTS MATERIAL
Pressure is too great on hand lever.
Decrease pressure on hand lever.
TACK-BUTTON ATTACHING MACHINE
48.
HANDLEVER STICKS ON DOWNSTROKE.
Check frame and handlever pivot for dirt or other obstruction.
Clean inside frame and pivot.
49.
UPPER DIE DOES NOT HOLD BUTTON FIRMLY.
Inspect upper die wires.
If upper die wires are loose or broken, replace die.
3-32
