TM 10-3530-207-14
4-55. STOWAGE BOX ASSEMBLY MAINTENANCE - continued.
Repair. Repair is limited to the following:
(1)
Replace a hinge as follows:
(a)
Remove ten rivets (1) and hinge (2)
from the stowage box (3).
(b)
Inspect and then replace parts as
required.
(c)
Install hinge (2) using ten rivets (1).
(2)
Replace catch/with strike as follows:
(a)
Remove four rivets (4) and
catch/with strike (5) from the stowage
box (3).
(b)
Inspect and then replace parts as required.
(c)
Install catch/with strike (5) using four rivets (4). Repeat for other side.
(3)
Replace handle as follows:
(a)
Remove five rivets (6) and handle (7).
(b)
Inspect and then replace parts as required.
(c)
Install handle (7) using five rivets (6). Repeat for other side.
(4)
Replace instruction plate and ID Plate as follows:
(a)
Remove damaged instruction plate (8) and ID Plate (9).
(b)
Clean adhesive surface of stowage box using a solution of detergent (Appendix F, Item 11) and
water.
(c)
Rinse thoroughly with clean water.
(d)
Allow to dry.
NOTE
Instruction and ID plates are self-adhesive.
(e)
Install new instruction plate (8) and ID Plate (9).
4-135